Всем привет!
Есть на руках такой аппарат в рабочем состоянии. Нужна помощь с снятии дампа.
Выставил dll от S5830.
На вкладке JTAG read/write жму Connect&GetID:
Код:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung S5830 V1.00]
Connecting to the dead body...OK
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Detected dead body ID: 0x503C10E1
Здесь же жму Analyze JTAG Chain:
Код:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung S5830 V1.00]
Connecting to the target...OK
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x503C10E1, IR Length = 0x04 bits
Total IR length: 0x0004 bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x503C10E1: Qualcomm MSM7227, H/W Rev. #5
Далее на этой же вкладке read memory:
Код:
Reading Target Memory...ERROR
ERROR: No response from the RIFF Box. at 0x00000000
На вкладке DCC read/write жму read memory (bypass ID check в special setting пробовал снимать/ставить лог одинаковый):
Код:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung S5830 V1.00]
Connecting to the dead body...OK
Detected dead body ID: 0x503C10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]
Settings Code: 0x37010009000000000000000010000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected a Not Initialized FLASH1 Chip, ID: 0xAAAA/0xAAAA (256MB)
Detected a Not Initialized FLASH2 Chip, ID: 0xAAAA/0xAAAA (256MB)
ERROR: Selected FLASH1 Chip was not Recognized by the DCC Loader. Terminating.
Как правильно слить дамп?