[Musaabkar]

Сообщение от Капитан_Джек

Сообщение

И у меня тоже ?
После такого же действия, также себя ведет....
Че за бред?
Элементарно, данная dll просто не корректно пишется, и все..

22.05.2012 10:07:46] [START OPERATION_ID = RESURRECT]
[22.05.2012 10:07:58] Open serial port...OK
[22.05.2012 10:07:58] Connecting to the RIFF Box...OK
[22.05.2012 10:07:58] Firmware Version: 1.32, JTAG Manager Version: 1.43
[22.05.2012 10:07:58] Selected Resurrector: [Samsung N7000 AP V1.0.4458.16492]
[22.05.2012 10:07:58]
[22.05.2012 10:07:58] Connecting to the dead body...OK
[22.05.2012 10:07:58] Detected dead body ID: 0x4BA00477 - CORRECT!
[22.05.2012 10:07:58] Set I/O Voltage reads as 2.80V, TCK Frequency is 4 MHz
[22.05.2012 10:07:58]
[22.05.2012 10:07:58] Resurrection sequence started.
[22.05.2012 10:07:58] Establish communication with the phone...OK
[22.05.2012 10:07:58] Initializing internal hardware configuration...OK
[22.05.2012 10:07:58] Uploading resurrector data into memory...OK
[22.05.2012 10:07:58] Starting communication with resurrector...OK
[22.05.2012 10:07:58]
[22.05.2012 10:07:58] Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0001 (VYL00M, 0x0003AB400000 Bytes = 14.68 GB)
[22.05.2012 10:07:58] Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0001 (VYL00M, 0x000000080000 Bytes = 0.50 MB)
[22.05.2012 10:07:58]
[22.05.2012 10:07:58] Flashing the dead body...
[22.05.2012 10:07:58] WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
[22.05.2012 10:07:58] ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000)
[22.05.2012 10:07:58] [FINISH OPERATION_ID = RESURRECT]

Коллега вы решили свою проблему? Пробовал на двух компах с XP и вин 7 тоже самое без изменений.