you need to have setool2 v1.1285 or higher.
you need to have test sim card ( with mnc/mcc 00101 ) in phone.
you need to have memory card in phone.
you need to have valid username/password with at least 3 credits.
phone should be in working state.
procedure is complicated and definitely NOT for beginners.
1.
flash any R7EA011 firmware into phone.
fully power on phone, wait until phone setup will be completed.
this is absolute requirement.
2.
run setool2, check that valid username/password entered, then go to "j108 bypass" tab.
press "upload executor package"
insert test sim card, memory card, connect powered off phone while holding "C" button
after initial procedure, disconnect phone , power on it, wait until setup complete and power off phone again.
3.
press "upload executor extractor"
insert test sim card, memory card, connect powered off phone while holding "C" button
after initial procedure, disconnect phone , power on it, wait until setup complete
set usb connection in phone options to "file transfer" and copy from memory card "other\executor.b" to setool2\backup\%imei% .
setool2 will open that folder for you in minimized state, check taskbar.
( if your system recognize phone as MTP device, you can copy file without setting USB connection to "file transfer" )
power off phone.
4.
press "unlock phone"
insert test sim card, memory card, connect powered off phone while holding "C" button
after initial procedure, disconnect phone , power on it,
set usb connection in phone options to "other OS"
install phone MODEM drivers, if required ( dist\drivers\Modem_Drivers )
wait, until setool2 finish procedure.
after setool2 finish procedure, do not disconnect phone from cable, do not remove phone battery, until phone powers on by itself.
otherwise you need to restore secunits backup and repeat step 3 from beginning.
this is not patch unlock, phone unlock is permanent
источник ...