Ошибки и обсуждение [CM2MTK MediaTek]

[yurii-62]

[DA_ERROR] : Correct BOOT CONFIGURATION not found for target!
Try Re-Install CM2MTK module!
Boot Error!

Какой модуль используете СМ? не указали. Установить последний InfinityBox CM2MT2, подгрузить ему правильную прошивку по идее должен забутить ТА. если с железом все в норме.

Пас на архив(12345678)

[densmen]

Сообщение от yurii-62

Какой модуль используете СМ? не указали. Установить последний InfinityBox CM2MT2, подгрузить ему правильную прошивку по идее должен забутить ТА. если с железом все в норме.

Пас на архив(12345678)

картина такая при попытке прошить. Может я выбираю не тот MODE : 0_base , просто не в курсе какой там должен для этого телефона стоять режим.

Infinity-Box [ Chinese Miracle ] MediaTek Service Module [ MTK ] v2.16

Load IDBase v729152 Ok!


Operation : Identify [ v2.16 ]
Mode : FLASH

1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : MediaTek USB Port (COM50)
MODE : BOOTROM
PORT : 50
Waiting BOOT ack ...
BROM : Skip ACK verify
BROM : Init BROM
BROM init passed!
     CHIP : MT6763 , SBID : 0x8A00 , HWVR : 0xCA01 , SWVR : 0x0001
     CODE : Bianco
     TYPE : MODERN RAPHAEL
BROM : MEID : DD5C697982F69FA102950CA2B3C6E138
BROM : SecLevel : 0x00000000
BROM : SecMode  : PLAIN [+PRL]
BROM : BROM|BL  : 0x05|0xFE
BROM : BOOTROM
MODE : 0_base : BASE_v2028 | Manual : Enabled
BROM : SOCID : 00C248103682C7B987B2439E5935A2A90866A08FC5584AA115A1A6BE8C397363
AGENT : Look for suitable BootChain in DA ... 
AGENT : MTK_AllInOne_DA.bin
AGENT : Found MT6763
AGENT : MTK_DOWNLOAD_AGENT
     BROM : Sending 1st DA ...
BROM : DA sent
BROM :Transfer control to DA ... 
     DA : AGENT started!
DA : SYNC
     DA : MODE : BROM
DA : EXT_RAM NOT initialized!
     EMI : DEV : MT6763
     EMI : SRC : preloader_g1929ep_v1_1gc_ym_a7pro1_eea_q.bin
     EMI : CNT : 0007
 EMI : [00] : eMMC : LP_DDR4X : ID : 150100444836444142 : VEN : SAMSUNG   | DEV : DH6DAB : RAM : [ 4,00 GB ]
 EMI : [01] : eMMC : LP_DDR4X : ID : 150100444836444D42 : VEN : SAMSUNG   | DEV : DH6DMB : RAM : [ 4,00 GB ]
 EMI : [02] : eMMC : LP_DDR4X : ID : 13014E53304A394438 : VEN : MICRON    | DEV : S0J9D8 : RAM : [ 4,00 GB ]
 EMI : [03] : eMMC : LP_DDR4X : ID : 13014E53304A394B38 : VEN : MICRON    | DEV : S0J9K8 : RAM : [ 4,00 GB ]
 EMI : [04] : eMMC : LP_DDR4X : ID : 90014A68433861503E : VEN : HYNIX     | DEV : hC8aP> : RAM : [ 4,00 GB ]
 EMI : [05] : eMMC : LP_DDR4X : ID : 13014E53304A333859 : VEN : MICRON    | DEV : S0J38Y : RAM : [ 4,00 GB ]
 EMI : [06] : eMMC : LP_DDR4X : ID : 90014A484347386134 : VEN : HYNIX     | DEV : HCG8a4 : RAM : [ 4,00 GB ]
     EMI : Init EMI from PRELOADER
     EMI : EXT_RAM CFG Passed!
DA : BOOT to 2nd DA ...

DA : BOOT 2ND DA FAILED!
ERR : 0xC0070004
ERR : DA_HASH MISMATCH

Error : Fail to init protocol!
>>> Remove battery, cable. Check cable/connection/driver! Check SW hint! Repeat operation!

Reconnect Power/Cable!

Сделал HW Report

Memory Info : 
    CID : 13014E53304A39443810003C03C8A4EF
    MEM : VEN : MICRON | OEM : 4E01 | DEV : S0J9D8
    DAT :  Size: 59640 MB, Max.Speed: 52000 kHz, blklen(512), nblks(122142720), ro(0)

EXT_CSD Info : 
EXT_CSD rev.		 : v1.8 ( MMC v5.1 )
     CSD struct rev.		 : v1.2
     Supported command sets	 : 1h
     HPI features		 : 1h
     BG operations support	 : 1h
     BG operations status	 : 0h
     Correct prg. sectors	 : 0h
     1st init time after part. : 4000 ms
     Min. write perf.(DDR,52MH,8b): 12h
     Min. read perf. (DDR,52MH,8b): 0h
     TRIM timeout: 0 ms
     Secure feature support: 55h
     Secure erase timeout  : 1632000 ms
     Secure trim timeout   : 1632000 ms
     Access size	     : 4608 bytes
     HC erase unit size    : 512 kbytes
     HC erase timeout      : 10200 ms
     HC write prot grp size: 8192 kbytes
     HC erase grp def.     : 0h
     Reliable write sect count: 1h
     Sleep current (VCC) : 8h
     Sleep current (VCCQ): 8h
     Sleep/awake timeout : 419430400 ns
     Sector count : 747c000h
     Min. WR Perf.  (52MH,8b): eh
     Min. Read Perf.(52MH,8b): 8h
     Min. WR Perf.  (26MH,8b,52MH,4b): 10h
     Min. Read Perf.(26MH,8b,52MH,4b): 8h
     Min. WR Perf.  (26MH,4b): 12h
     Min. Read Perf.(26MH,4b): 8h
     Power class: 0
     Power class(DDR,52MH,3.6V): 0h
     Power class(DDR,52MH,1.9V): 0h
     Power class(26MH,3.6V)	 : 0h
     Power class(52MH,3.6V)	 : 0h
     Power class(26MH,1.9V)	 : 0h
     Power class(52MH,1.9V)	 : 0h
     Part. switch timing    : 1h
     Out-of-INTR busy timing: ffh
     Card type       : 57h
     Command set     : 0h
     Command set rev.: 0h
     HS timing       : 0h
     Bus width       : 0h
     Erase memory content : 0h
     Partition config      : 48h
     Boot partition size   : 4096 kbytes
     Boot information      : 7h
     Boot config protection: 0h
     Boot bus width	     : 0h
     Boot area write prot  : 0h
     User area write prot  : 0h
     FW configuration      : 0h
     RPMB size : 4096 kbytes
     Write rel. setting  : 1fh
     Write rel. parameter: 15h
     Start background ops : 0h
     Enable background ops: 2h
     H/W reset function   : 1h
     HPI management	    : 0h
     Max. enhanced area size : 9b4h (20348928 kbytes)
     Part. support  : 7h
     Part. attribute: 0h
     Part. setting  : 0h
     General purpose 1 size : 0h (0 kbytes)
     General purpose 2 size : 0h (0 kbytes)
     General purpose 3 size : 0h (0 kbytes)
     General purpose 4 size : 0h (0 kbytes)
     Enh. user area size : 0h (0 kbytes)
     Enh. user area start: 0h
     Bad block mgmt mode: 0h

Overall status : 

    MLC status : 0% - 10% used
    SLC status : 0% - 10% used
    EOL status : Normal  ( Less than 80% reserved blocks used )

[yurii-62]

ТА не ударник или топленник случаем, смотрели? СМ как бы на память грешит, тут я конечно могу и ошибаться, но вряд ли..