[Serge94]

простите за задержку, болел, продолжаем,
Кпк так и не подали признаков жизни

у одного однозначно проблемы с флешкой, а у второго после удачного "resurection"кпк не заводится и не входит в бут? выкладываю лог .

лог восстановления

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.15, JTAG Manager Version: 1.18
Selected Resurrector: [HTC HD]

Connecting to the dead body...OK
Detected dead body ID: 0xA01700E1 - CORRECT!
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OKDetected an Initialized FLASH1 Chip ID: 0x0000/0x01EC (1MB)
Flashing the dead body...OK
Resurrection complete!

причём если выбрать корректировку ID то процес заканчивается с ошибкой те после 100% .

ошибка id

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.15, JTAG Manager Version: 1.18
Selected Resurrector: [HTC HD]

Connecting to the dead body...OK
Detected dead body ID: 0xA01700E1 - CORRECT!
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip ID: 0x0000/0x55BC (512MB)
Flashing the dead body...ERROR
ERROR: Failed to Write Custom ID.

ошибка на 75% при выборе корректировки IMEI

ошибка imei

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.15, JTAG Manager Version: 1.18
Selected Resurrector: [HTC HD]

Connecting to the dead body...OK
Detected dead body ID: 0xA01700E1 - CORRECT!
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip ID: 0x0000/0x01EC (1MB)
Flashing the dead body...ERROR
Failed to repair IMEI with current partition state!