| 
	
		
		
		
		 
			
			Такая же песня! 
Подключи дисплейный модуль, поставь АКБ, тыкай кнопку вкл, затем восстановление, да же не думай подключать USB.  
 
[11.01.2013 16:15:05] [START OPERATION_ID = JTAG_ANALIZE] 
[11.01.2013 16:15:06] Open serial port...OK 
[11.01.2013 16:15:06] Connecting to the RIFF Box...OK 
[11.01.2013 16:15:06] Firmware Version: 1.34, JTAG Manager Version: 1.48 
[11.01.2013 16:15:06] Selected Resurrector: [Samsung I9070P V1.0.4705.16925] 
[11.01.2013 16:15:06]  
[11.01.2013 16:15:06] Connecting to the target...OK 
[11.01.2013 16:15:06] Set I/O Voltage reads as 1.80V, TCK Frequency is 12 MHz 
[11.01.2013 16:15:06]  
[11.01.2013 16:15:06] Following devices are found on the JTAG chain: 
[11.01.2013 16:15:06]   Device on TAP #0: ID = 0x4BA00477, IR Length = 0x05 bits 
[11.01.2013 16:15:06]   Device on TAP #1: ID = 0xFFFFFFCF, IR Length = 0x01 bits 
[11.01.2013 16:15:06]   Device on TAP #2: ID = 0xFFFFFFFF, IR Length = 0x01 bits 
[11.01.2013 16:15:06]   Device on TAP #3: ID = 0xFFFFFFFF, IR Length = 0x01 bits 
[11.01.2013 16:15:06]   Device on TAP #4: ID = 0xFFFFFFFF, IR Length = 0x01 bits 
[11.01.2013 16:15:06]   Device on TAP #5: ID = 0x000000FF, IR Length = 0x01 bits 
[11.01.2013 16:15:06] Total IR length: 0x000A bits 
[11.01.2013 16:15:06]  
[11.01.2013 16:15:06] Analizing IDCODE(s) of the JTAG scan chain: 
[11.01.2013 16:15:06] 1. 0x4BA00477: Samsung S5PV300 
[11.01.2013 16:15:06] 2. 0x4BA00477: NovaThor U8500 
[11.01.2013 16:15:06] 3. 0x4BA00477: Generic CORTEX-A9 
[11.01.2013 16:15:06] [FINISH OPERATION_ID = JTAG_ANALIZE] 
 
[11.01.2013 16:15:09] [START OPERATION_ID = RESURRECT] 
[11.01.2013 16:16:44] Open serial port...OK 
[11.01.2013 16:16:44] Connecting to the RIFF Box...OK 
[11.01.2013 16:16:44] Firmware Version: 1.34, JTAG Manager Version: 1.48 
[11.01.2013 16:16:44] Selected Resurrector: [Samsung I9070P V1.0.4705.16925] 
[11.01.2013 16:16:44]  
[11.01.2013 16:16:44] Connecting to the dead body...OK 
[11.01.2013 16:16:44] Detected dead body ID: 0x4BA00477 - CORRECT! 
[11.01.2013 16:16:44] Set I/O Voltage reads as 1.81V, TCK Frequency is 12 MHz 
[11.01.2013 16:16:44]  
[11.01.2013 16:16:44] Resurrection sequence started. 
[11.01.2013 16:16:44] Establish communication with the phone...OK 
[11.01.2013 16:16:44] Initializing internal hardware configuration...OK 
[11.01.2013 16:16:44] Uploading resurrector data into memory...OK 
[11.01.2013 16:16:44] Starting communication with resurrector...OK 
[11.01.2013 16:16:44]  
[11.01.2013 16:16:44] Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0000 (SEM08G, 0x0001D2000000 Bytes = 7.28 GB) 
[11.01.2013 16:16:44] Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0000 (SEM08G, 0x000000200000 Bytes = 2.00 MB) 
[11.01.2013 16:16:44]  
[11.01.2013 16:16:44] Selected Resurrection Data for the eMMC Chip with Capacity = 7,28GB 
[11.01.2013 16:16:44]  
[11.01.2013 16:16:44] Flashing the dead body...OK 
[11.01.2013 16:16:44] Resurrection complete! 
[11.01.2013 16:16:44] [FINISH OPERATION_ID = RESURRECT] 
 
это же тело только месяцем раньше!  
 
[12.12.2012 15:00:50] [START OPERATION_ID = RESURRECT] 
[12.12.2012 15:01:03] Open serial port...OK 
[12.12.2012 15:01:03] Connecting to the RIFF Box...OK 
[12.12.2012 15:01:03] Firmware Version: 1.34, JTAG Manager Version: 1.48 
[12.12.2012 15:01:03] Selected Resurrector: [Samsung I9070 V1.0.4705.16773] 
[12.12.2012 15:01:03]  
[12.12.2012 15:01:03] Connecting to the dead body...OK 
[12.12.2012 15:01:03] Detected dead body ID: 0x4BA00477 - IGNORED! 
[12.12.2012 15:01:03] Set I/O Voltage reads as 1.81V, TCK Frequency is 12 MHz 
[12.12.2012 15:01:03]  
[12.12.2012 15:01:03] Resurrection sequence started. 
[12.12.2012 15:01:03] Establish communication with the phone...FAILED 
[12.12.2012 15:01:03] ERROR(0x59): Communication is not established. Terminating. 
[12.12.2012 15:01:03] [FINISH OPERATION_ID = RESURRECT] 
 
Глянь на dll 
// Кстати восстанавливал на W7(x86)
		 
		
		
		
		
		
		
		
		
			
				  
				
					
						Последний раз редактировалось haydeGen; 11.01.2013 в 16:34.
					
					
				
			
		
		
	 |