Eten Glofish X600 восстановление boot

[DimanG]

Влил я твой файлик

Запись

[12.07.2011 11:44:04] [START OPERATION_ID = DCC_WRITE_MEMORY]
[12.07.2011 11:44:18] Open serial port...OK
[12.07.2011 11:44:18] Connecting to the RIFF Box...OK
[12.07.2011 11:44:18] Firmware Version: 1.25, JTAG Manager Version: 1.33
[12.07.2011 11:44:18] Selected Resurrector: [Eten X800]
[12.07.2011 11:44:18]
[12.07.2011 11:44:18] Connecting to the dead body...OK
[12.07.2011 11:44:18] Detected dead body ID: 0x0032409D - CORRECT!
[12.07.2011 11:44:18] Set I/O Voltage reads as 2.61V, TCK Frequency is 8 MHz
[12.07.2011 11:44:18]
[12.07.2011 11:44:18] Resurrection sequence started.
[12.07.2011 11:44:18] Establish communication with the phone...OK
[12.07.2011 11:44:18] Initializing internal hardware configuration...OK
[12.07.2011 11:44:18] Uploading resurrector data into memory...OK
[12.07.2011 11:44:18] Starting communication with resurrector...OK
[12.07.2011 11:44:18]
[12.07.2011 11:44:18] Detected an Initialized FLASH1 Chip ID: 0x00EC/0x00A1 (128MB)
[12.07.2011 11:44:18]
[12.07.2011 11:44:18] Writting FLASH1 memory from 0x00000000 to 0x002BFFFF
[12.07.2011 11:44:18] Completed in 00:00:13.562 (Average Transfer Rate: 214.13 kB/s)
[12.07.2011 11:44:18] [FINISH OPERATION_ID = DCC_WRITE_MEMORY]